Pond Guard Paint Sealer 4L (2 x 2L)

POND GUARD is a two-part water-based epoxy membrane sealer for ponds and water features. POND GUARD is a non-toxic sealer that conforms to the Australian Drinking Standards requirements set out for AS4020.2000 and BS6920. Part A and Part B cover a total of 6 square metres using 2 coats. 

POND GUARD must be applied to dry and fully cured concrete. Best results are achieved if the concrete is wet with a fine mist and just allowing the surface to dry prior to application. Apply POND GUARD using a roller or brush. Care must be taken when working the sealant into voids and avoid pinholing. Apply POND GUARD evenly and rework areas with a roller or brush to get an even finish. A MINIMUM OF 2 COATS IS REQUIRED TO ACHIEVE WATERPROOFING. Allow 4 hours of curing time between coats. Allow POND GUARD to cure for 24hrs before applying water-based adhesives, mortars, levelling compounds, decorative coatings or surface treatments. Care must be taken to make sure the POND GUARD waterproofing membrane is
not damaged during application of subsequent surface treatments.

POND GUARD INSTRUCTIONS PDF